Before starting, you should first use a slide projector to draw the pattern onto the glass (a yellow tape on the glass, and a pattern printed on the tape on the tape), then use a utility knife to cut off the tape that needs to be carved, and put the glass into the machine. Carved inside, the tool inside the machine is similar to the spray gun, the glass of the part without the tape is sprayed, and the glass is worn away, which becomes the carving.
The traditional method is to use the engraving machine to engrave the pattern on the sandblasting film, then transfer it to the glass, and then sandblasting. After applying the glass engraving machine, the sandblasting film can be directly attached to the glass to be processed, and then The film to be processed is placed on a vertical glass engraving machine to engrave the pattern, thereby greatly saving manpower and time cost, and also completely avoiding the deviation of the paper generated by the conventional computer engraving machine when carving complex patterns, shifting And scribbling problems, as well as scrapping problems caused by improper handling of the processed film during reposting.
If you manually engrave the glass, it is better to use the diamond head. The specific process is as follows. Rinse the glass, do not leave any oil stains. Add the paraffin and appropriate amount of gasoline to dissolve it, evenly draw on the glass. Finally, after the paraffin is solidified, use it first. The blunt is drawn with a pattern and then engraved along the line until the glass is visible.
If you are using a carving tool, use a double-edged milling cutter. If you are making a tool in Wentai or Jingdiao, you should choose counterclockwise. To be smooth, one is to go counterclockwise or clockwise, but the steel of the milling cutter is fast. Note that after the depth is adjusted, you need to clear z, and set the engraving depth on the file, but do the file first. See what engraving software you use. In fact, it is very simple. If you want the cutting surface to be smooth, It is best to use imported single-edged milling cutters.
