Four solutions to some minor problems in woodworking engraving opportunities

We all know that the use of mechanical equipment will inevitably present some small achievements. The original carpenter engraving machine is no exception. Some reasons are caused by the achievements of the machine itself. Some reasons are caused by the mistakes of the operation staff. The mechanical small series will let us introduce the four major achievements of the original woodworking carving machine!
One: the process of woodworking carving machine operation, the spindle motor suddenly stopped or turned slow.
Reason for the cause:
1. The operating voltage is unstable or overloaded, and a voltage regulator can be added.
2. Introspection can be made in the middle line, can the wire head be de-welded.
Two: Woodworking carving machine can not be carved at the origin.
Reason for the cause:
1. Can the layout size of the file match the machine?
2. Introspection can be set to offset (OFFSET), can the layout settings be accurate.
Three: Woodworking engraving machine announces abnormal static or always top bad limit switch when starting reset
Reason for the cause:
1. The top is not limited to the limit switch, and it can be corrected.
2. The drive line is not well touched and the drive line is strong.
3. The limit switch line is not connected, and the line can be connected.
4. The limit switch is damaged and can be replaced.
Four: When the woodworking machine sets the origin, it occasionally shifts forward or shifts to the right and the offset distance is uncertain.
Reason for the cause:
1. The limit switch is faulty. When the system returns to the original point of the system, the limit switch is closed and popped open. Replace the limit switch.
2. The drive line is loose. Try to keep it firm and tight.